Urban Chicken Coop.Com:
Killer Mistakes to Avoid!
How to build chicken nesting boxes?
Urban Chicken Coop.Com is all about knowing what you are doing. Inside the coop, nesting box takes an important place. Through layers, required amount of safety is offered to the roosters. Business of perching eggs is concluded in a casual speed with additional level of comfort. Cleaner atmosphere is offered in the process. Protection is provided from every side. In some occasions, birds eat their egg own offspring without any knowledge.
Development of behavioural problems are seen within the hens as a result. By creating area for perching, above issue is resolved in a credible manner. If you do not want to spend your money for a unit that is readymade then a simple chicken nest box plans can be searched.
Boxes for nesting can be made separately. However, it is mostly placed within the bird shelter. Complete focus is generally shifted towards a light design. Mobile set up is generally guaranteed with these designs. However, sturdiness of the box must not be sacrificed. In the section, more overlooked facts about Urban Chicken Coop.Com will be revealed.
Urban Chicken Coop.Com — How to save money?
By using salvage or scrap material, cost of making the nesting container can be reduced. From single plywood, you can cut a section that is 4” X 8”. Broadness of sheet is generally limited up to 1”.
Tools required
- Measuring tape
- Saw horses
- Circular saw
- Pencil
- Straight edge
- Drill
- Driver bit
Material required
Plywood, furring strips, lumber, wood screws for exterior, finishing nails, linseed oil (boiled) and sand papers are required for the box. After acquiring all these materials, it is better to understand how to build a chicken nesting box.
Building the box for nesting
Splinters are generally removed from the plywood through proper use of sand papers. Smooth edge is necessary for perching. In case of un-painted wood, linseed oil is coated for preservation. Lesser amount of mites can be observed in due course. In fact, very few websites list the following points while addressing Urban Chicken Coop.Com.
- Adding Cleats
In the end walls, cleats must be attached. Height of both the cleats from the bottom should be about 6” and 18” respectively. Placement of the third is at the centre. Utilization of wood screws is seen for the purpose. Pre-drilling is not required. Similar method must be applied for other walls as well.
For the middle walls, 3 ½ “screws are placed on reverse sides with every cleat. Space with same diameter is created through a pre-drilling session.
- Inserting shelves
In between middle and end walls, first shelf can be placed. Security is offered with 1” screws. It is always better to keep another set. Second shelf is affixed on top of first. Shelves are adjoined according to requirement. Measurement of the structure is taken during this time. In case you are looking for DIY plans, here is the detailed guide and our best recommendation that is Teds woodworking.
- From the back and top
By using finish nails, ¼” plywood is fitted. Square assembly is preferred. Best results are achieved with straight edge. Nails are pushed back to eliminate any chances of accidents. If the roosters are poked from the back then they may not use the mechanism at all. From the top, plywood must be attached with the assistance from screws.
- Create front rails and perch
Above the shelves, front rails are placed. Material for bedding is usually kept safe with this strategy. Four are added from end, top and bottom. More importance must be given while placing the rails on peak. In addition to the frontage rails, perch rails are placed.
