Simple Tips on Garage Door Troubleshooting

It is understandable if you probably have not been devoted to your garage door functionality and stability. Most people also don’t. However, it is high time that you wave goodbye to your comfort zone and think about your garage door springs for a while. The springs play a vital role in raising and lowering the garage door, which to some extent account for the safety of the operator. The safety mechanism of the garage door might be hindered with faulty garage door springs. This definitely raises the alarm on the dire need to consider garage door spring repair, just in case they are faulty, or if in doubt that they might not be working well.

Apart from the garage door springs, there might be other problems that can cause irritation to the smooth operation of the garage door. As the car and garage owner, you definitely need these tips, unless you aren’t concerned about your safety and that of that of any other person that operates the garage door. Here are a few helpful tips on troubleshooting the garage door opener.

First of all, you need to have a simple knowledge on how the garage door opener works. It is not a must but is essential for a successful troubleshooting. Then you should check whether the car remote control can activate the garage door opener. If this does not work, probably the remote battery is low. Try to replace the batteries with new ones and try to activate the opener once more. This is normally the best troubleshooting tip to start with as it will detect any issues with smooth operation of the garage door opener.

The next troubleshooting tip is commenced once the above tip proves that the garage door opener has faults. If the car remote works well, but the wall control unit does not activate the door opener, you should check the source of power. Some wall control units are powered by batteries while others use the electricity. If your wall unit is powered by batteries, test them to see they are fine. If powered by electricity, check the wiring system to identify possible broken or exposed wires, or scorched points. If there are defects, consult an electrician otherwise, rule out the issue of electricity.

Another cause of faulty garage door opener may be the case of blocked sensors. The sensor usually are in pairs with each at either side of the walls. One produces red beam of light while the other produces green. When the sensors are blocked, it can be the result of the failure. Blocking can be as a result of dirt or any other possible cause. Faulty sensors can also cause the door to fail to open completely.

In the case where the garage door reverses after or before closing, the possible cause can be close limit switch. You should check it and adjust as required. Sometimes the door can reverse immediately before touching the ground. This can be caused by a case of adjustment in the opener unit. This can also be caused by worn out springs for older garage door opener. If your garage door opener is old, you should consider garage door spring replacement as a long lasting solution to irregular opening and closing of the door opener.

If the garage door closes or opens but the motor continues to run, the problem can be the limit switch. The switch should be adjusted appropriately, either on the track or rear of opener unit.