Nash TUHPC Simulation in ADSFor advanced SI engineers, Batched Simulation is a useful trick to consider big enough scope to make sure our design can cover all…5d ago5d ago
Nash TUCOM Calculation in ADSIt is suggested by IEEE to run COM (Channel Operating Margin) for Ethernet channel analysis if there are no accurate TX and RX models…Aug 14Aug 14
Nash TUStandard-driven AMI ModelsAMI(Algorithmic Model Interface) is the short name of IBIS-AMI. AMI has done a good job helping SI engineers simulate with the models…Aug 131Aug 131
Nash TUWho needs Compliance for Simulation?It is inevitable for SI engineers to “interact” with compliance reports.Aug 12Aug 12
Nash TUDDR AMILet’s look at the progress of SerDes. Before 2007, SerDes speed grade are below 5Gbps, so it is useful and straightforward to use either…Jun 29, 2023Jun 29, 2023
Nash TUProbes in ADS Memory DesignerThere is a big difference between DDR and SerDes analyses. One key point is the Forward Clocking used by DDR. This article will discuss all…Jun 29, 2023Jun 29, 2023
Nash TUADS Convergence Issue: Internal Timestep too SmallIt is often to get notified “Internal Timestep too small” while running Time Domain simulation. It it due to circuit simulator fails to…Jun 27, 2023Jun 27, 2023
Nash TUHow To Extract From Large SNPMost of the time, we receive some SNP with tens or hundreds of ports. But sometimes only few ports are of interest.Jun 27, 2023Jun 27, 2023