UX Network User Guide
Register Account
First, click the register icon on the top right-hand corner.
Next, you will see the login and register tabs, now click register. Input the requested information and accept our terms (After reading) and click the arrow to proceed.
Next, you will be shown a verification box. This is a code sent via email. Please input the code (Please check the junk folder if you have not received this).
The account should now be registered. Please login with your details.
Verify Identification
First, click on the account tab at the top and then click the highlighted verify box.
Next, fill in your personal information making sure all the required sections (The ones highlighted with a red star) are filled in.
Next, you will see where you can add your identification. Make sure the correct country and ID type is selected.
To check what type of documents are available in your country, click the show supported button below.
Make sure once the ID is uploaded, all four corners of the identification is shown, and all the information is visible. Please make sure that no fingers or faces are in the picture, and no information is covered up.
Also, make sure that the photo has good lighting and no glare and that the identification is in good condition, once this is done click next.
It will now prompt you to confirm all the information inputted, once confirmed, click submit. When you have submitted, there is no reason to resubmit unless rejected. If there are any issues with your submission, please contact info@asynq.one
Claim WORBLI Snapshot
Please complete KYC verification first. The address verification is not a requirement of the WORBLI claim.
First, click on the networks tab at the top. Once there you can click accounts and then the import account button.
Type in the WORBLI account name that you would like to prove ownership. If you have more than one account that you would like to claim you can add multiple accounts.
If you receive the error below, this usually means that there were no tokens in the WORBLI account at the time of the snapshot. If you have an issue, please contact us via email as stated.
Next, you should see the box in the picture below (information will be filled in). Next click prove ownership.
Select the software you would like to use for proving ownership. Make sure your third-party software is open and logged in. If you have issues with your third-party software, we suggest going to the software developer’s telegram channel to fix the problem.
The Owner key from WORBLI must be used and not the Active key for proof of ownership.
Once you have proven ownership to all your accounts, you can then go to finalize to confirm all WORBLI account claims. Once done, you can move onto the UX account creation.
UX Account Creation
First, click on the networks tab at the top and then create an account.
Now you can see all UTX and UTXRAM you can access. To create an account, it will use some of the UTXRAM each time, so make sure you have selected to use a minimum of 5 UTXRAM. However, if you are looking to create more than one account, make sure you keep some UTXRAM to create further accounts.
The pre-set will use all of your UTX and UTXRAM. It will also use the public keys that you used on the WORBLI network. If you would like to change the amounts or keys, please deselect the tick boxes, and then the token amounts and key areas will then show in white and be editable as shown below.
Once you have added an account, it will show how much is in that account as seen below.
