Hello
thank you for educating people about this, the only problem I have is you said even the regular lighter make your glass black do not use a torch.
when the lighter has yellow flame it is not burning complete since not enough oxygen provided for so the result is having carbon monoxide (co) and carbon by itself, both of these are not good to inhale, carbon monoxide kills your blood hemoglobin that you need it to carry oxygen through your body and carbon deposit in your lungs airbags and you can not use it one hundred percent to catch oxygen, in the other hand the carbon goes through the pipe and make you meth black too,. so is better to use a blue flame, blue flame shows complete burning of fuel, there is a wide range of blue flame from dancing blue flame that is low temperature, to sharp blue flame with a lot of air pressure noise that is high- temperature, now how to get dancing blue flame? if you are using regular lighter get very close that the flame touches the glass it will turn blue since you are spreading flame and it touches more oxygen if using a torch make more distance from glass and inhale more, there is two way to make a dancing blue flame.
1, add more oxygen to regular lighter. or somehow spread the flame. I used a torch tip and attached it to regular lighter it works there are some problems that I do not have time to deal with.
2, give less oxygen to torch. I inserted a small metal pin in the center hole of torch tip and it works.
there is one rule, as long as you inhale, the airflow prevents the meth to burn so hotter flame harder inhale or more distance between flame and glass, and don't forget always turn off the flame first and after few seconds stop inhaling, this causes your pipe and meth get cool.
I have more suggestions.
when you get your new glass pipe use a regular plumber torch heat the hole area and when it is hot enough then push the hole in and it creates the funnel, it has two advantage
1, when you loading from hole the funnel helps you load without wasting it.
2, when you have hot melted material and accidentally turn the hole down the hot liquid can not go out to burn someone.
another suggestion is if you bought material that you fill is not pure you can wash it to be sure is better quality, use pure acetone (not nail polish remover) you can obtain it from home depot. acetone is a cleaner so dissolve lots of material but can not dissolve the meth. so make your meth as powder as possible in a glass jar, add acetone and send it through the coffee filter the remaining on the coffee filter is good material, spread it let all acetone evaporate 30 min. to one hour, then you can use your material.
note: using meth is a wrong thing to do, nothing is better than being sober, if you have to use it then I am here to help to at least use it as healthy as possible, these are only my suggestions to help, my friends use it and it works, but i do not want to be responsible for any of my suggestions so you must educate yourself before using these suggestions.
i hope it is helpful
i hope it helps .