How To Repair The Old Anti-Static Floor?

The Raised Floor Steel Perforated Panel Supplier teaches you about the maintenance of the anti-static floor.

General maintenance methods are:

1. Clean the surface of the old anti-static floor;

2. Clean the surface of the old anti-static floor;

3. Apply adhesive evenly to the cut new anti-static surface;

4. Evenly glue the cleaned floor surface;

5. After the anti-static surface glue and floor surface glue are dry, paste them.

The anti-static technology of the machine room is a part of the safety and protection of the machine room. Because of a variety of reasons and the generation of static electricity, is frequent, difficult to eliminate one of the hazards. Static electricity will not only cause random failure, misoperation or calculation error in computer operation but also lead to breakdown and destruction of some components, such as CMOS, MOS circuit, two-stage circuit, etc. The cost of repair depends on the technical requirements of the anti-static veneer selected by the customer. If the surface of the original anti-static floor is uneven, or has been deformed, or has been damaged, or the quality of its own products, then the floor is also unable to repair.

The problems caused by electricity are not only difficult for hardware personnel to find but also sometimes software personnel mistake them for software failures, thus causing work chaos. In addition, static electricity through the body of the computer or other devices when the discharge (so-called tinder) when the energy reached a certain level, also give a person to feel electric shock. In addition, static electricity also has a significant impact on the computer’s external equipment. The display device with the polarizing tube, when subjected to static interference, will cause image disorder, blurring. Static electricity will also cause Modem, network card, Fax and other work disorders, printer line is not the fault.

Our company also provide Slant 16°Steel Weld Perforated Panel, welcome to contact us.