Surface grinder operation and routine maintenance of Association 

minging equipment

To extend the life of equipment , ensure processing quality , increase productivity, production safety norms formulated rules.
1. surface grinding machine manufacturers in india basic requirements
The operator of surface grinding machine manufacturers in india must be familiar with the sequence of operations and performance of the machine , master , “ Miyoshi “, “ four” requirements, “Miyoshi “ refers to manage , use , protect ; “ four” refers to the use , will be maintenance checks , are excluded general failure.
2 before the daily work on the grinder conduct a comprehensive inspection to confirm the situation is normal grinder .
2-1 Check the motor is functioning properly, whether ventilated wire for wear contact reliability .
2-2 surface grinding machine manufacturers in india inspection hole , tubing , oil to flow, pipe joints should be strong, no leaks, oil spills, bright window to check the oil standard oil level, according to the lubrication chart grease lubrication equipment ;
2-3 Check the handle rotation is flexible , stalls are in the desired position , switches, knobs are sensitive safety device is valid ;
2-4 surface grinding machine manufacturers in india check whether the normal magnetic suction table ;
2-5 Check the coolant pump is functioning properly, the cooling pipe is smooth , filter and coolant whether the debris , scrap iron ;
2-6 before the machine , rear, left , right, upper and lower direction of each slide is normal.
3.surface grinding machine manufacturers in india basic steps:
3-1 with a clean cloth to wipe the rust oil workbench .
3-2 According to the workpiece material and manufacturing processes , and put on the required specifications have good balance wheel .
3-3 . Underside using a diamond wheel dressing pen , or on its side need trimming . Diamond pen holder gripped , prohibit the use of hand wheel dressing diamond pen .
3-4. The wheel rises again to wipe clean table .
3-5. Workpiece clamping must be removed early glitches , the pad should be appropriately chosen to prevent flying workpiece , the workpiece light on the bench and use the side of the bezel and pad accurately positioned on the workpiece and the magnetic fixed after confirmation of the workpiece firmly suck , to start processing.
3-6. Grinding on when the knife is required on ( the highest point of the work ) easily accessible to the painted surface color , the color of the time to wipe the knife wheel prevail . Grinding into the amount to be uniform, and only when the wheel away from the workpiece before plunging .
3-7 when the first plunging slowly feed the workpiece length adjusted and fixed limit file reciprocating iron .
3-8 before starting wheel hydraulic drive should handle on “Stop “ position , adjust the speed of the handle on the “ lowest “ position , the handle on the wheel fast-moving “back” position , when the power to prevent a sudden shock.
3-9 entering the normal grinding operations, the amount of grinding required to select the appropriate processing .
3-10 when grinding Longitudinal feed to be small, no amount of feed air trips to more adequate , not allowed to leave traces of wheel passes .