Common Problems with Garage Door Openers & How to Fix Them
Has your garage door opener been acting up lately? If your answer is yes, this blog post is for you. Even if you go for a high quality garage door opener, there comes a time when it completes its expected lifespan calling for the attention of an repair professional. Continuing the discussion, this blog post outlines some of the common problems that manifest in garage door openers, and their possible remedies. Read on.
Malfunctioning remote control or switch
If your garage door doesn’t budge no matter how much you press the remote control or the wall switch, a probable cause for this is disruption in the power source. To troubleshoot the problem, check the cords and make sure they are plugged in. The problem may also lie with the fuse or ground fault circuit interrupter following a short circuit, or simply the motor of the door opener has gone bad. In this case, you need to hire garage door repair services.
Door opening partially
If your garage door starts to open normally but stops midway, there can be two possible causes. Either the up-limit switch is too far from the motor unit or the rollers are damaged. If the problem is with the switch, then move the switch closer to the unit. If the rollers are damaged, they can also cause the door to stop at the wrong places. Inspect the rollers, lubricate the rusty ones, and replace the unsalvageable.
Door doesn’t close completely
If your garage door doesn’t close completely, this can be due to the close limit switch requiring adjustment. Adjust the switch to stop the door from behaving erratically. If the problem lies with the electronic sensors near the bottom of the door, the problem might be triggered by some foreign particles blocking the path. Another cause, though relatively rare, is rusted or damaged rollers, which can cause the door to bind up in its track. Lubricate rusted rollers and replace the damaged ones.
Door reverses before touching ground
Many people face the problem of their garage door making a quick reverse before it touches the ground. In such cases, the close-force screw setting needs adjustment. Any undue friction in the rollers can send a wrong signal to the opener that the door has reached the floor, which stops it before the door touches the ground. In such cases, check and make sure the rollers are in good condition and free of rust.
Wrap Up
These are some of the problems with garage door opener that are quite common in both residential and commercial garage doors. However, whether it is a private garage door or loading dock door repair need, help is just a call away. If you need any assistance with your garage door opener, get in touch with a licensed garage door installation, repair, and replacement company near you. Simple search the web to find a trusted overhead doors services company in Dallas and other places in Texas.