3D Printed V Tail

1-2-HAK
1-2-HAK
Jan 17, 2015 · 2 min read

I have been looking for a while for a small v tail to build to get the benefits of high yaw on a racing style quad.

I came across the plans here on Thingiverse http://www.thingiverse.com/thing:596820

Originally just posted as a work in progress I decided I would break down the stl file and see if I can fly it. It was a lot of work to do that but in the end success.

Running cleanflight on naze in vtail config it was extremely hard to tune. I had to increase roll p to about 7 and add a lot of d to get it to dampen. After quite a few flights it snapped at the tail secttion during flight.

There is a new version release on the Thingiverse page and I will reprint an repost the cleanflight settings once done.

Overall this thing has potential.

    Welcome to a place where words matter. On Medium, smart voices and original ideas take center stage - with no ads in sight. Watch
    Follow all the topics you care about, and we’ll deliver the best stories for you to your homepage and inbox. Explore
    Get unlimited access to the best stories on Medium — and support writers while you’re at it. Just $5/month. Upgrade