DON’T REPLACE, REPAIR! Learn how to recondition a car battery, with ease
There are hundreds of batteries available on the market, and over time, they stop functioning, and we throw them away. But you know what? It is a common misconception that batteries need to be replaced after they stop working, especially Lead Acid Batteries. Do YOU believe that? Well, if yes, you would be surprised to know that you are wrong.
Like everything other battery, acid batteries over time become inefficient and can damage the car or UPS or other devices. However, battery restoring is possible, which not only protects your vehicles and other gadgets but is cost-effective too. Reconditioning is a method used to restore batteries, and How to recondition a car battery is what we are going to tell you today.
Reconditioning Lead acid battery can be done in multiple ways if you’re fortunate enough, you’ll be done in no time with minimum effort, but if not, you’ll be stuck for a quite long time. However, you need to know that learning how to recondition batteries is a dangerous task. But don’t need to worry if you make sure to be cautious and keep following the procedure laid out down below.
See also ……8 Simple Tips & Tricks To Extend The Life Of Your Car Battery
THE QUICK SIMPLE METHOD
Step 1: Charge the battery
If you know how to recondition a car battery, you would know how essential it is to charge the battery beforehand, no matter if it does or doesn’t function properly. Charge the batteries for at least 12–15 hours and then let them rest for 10 -20 minutes before salvaging it.
Step 2: Remove the lid
No matter what the material your battery is made up of, you can easily remove them. Once that is done, all you need to do is carefully unscrew three holes and then measure the voltage of the battery.
Step 3: Add distilled water
After measuring the volt, you’ll notice that the battery is dry or almost dry; this is why it is not performing well. Now what you need to do is fill each compartment (not entirely) with distilled water to activate the acid. Remember not to use a syringe or other apparatus that will ensure a precise result. Remember, spillage can cause a spark and can have an uncertain outcome. Once you are done filling the compartments, you need to recheck the volt, and it needs to be around 12–14 volts. If you get the required result, then just take out the water with the help of a syringe, close the lid. Guess what you’re Done! And need not to read further.
See Also …7 Ways To Prolong The Life Of Deep Cycle Lead-Acid Batteries
THE LENGTHY METHOD
And unfortunately, if you haven’t gotten the required result, you’re in store for a bit more effort. Tiring we know, but this how-to recondition old batteries.
Step 4: Add a mixture of Acid and water
If distilled water wasn’t enough, this means the cells were fragile and need an additional kick. Well, how to recondition batteries now will be your question. Well, all you would have to do is now fill the compartments with acid now (mixed with new distilled water) and recharge it. You’ll see bubbles popping out the three holes.
Step 5: Rearrange the charger
If the bubbles don’t come out, don’t panic reverse negative and positive voltage, and you’ll see bubbles coming out in few minutes, then quickly change the packs the way they were, and your battery is good as new.
Step 6: Seal the deal
Don’t get excited too much on our guide of how to recondition batteries; you’re still left with one step. Carefully drain out the water from the three holes, completely dry the battery and let it charge for an hour for it to start functioning correctly.
So here you go folk, this is how to recondition a car battery, and we have spilled all the steps for you to get that battery functioning accurately quickly. So say goodbye to mechanics and those expensive acid batteries, because this article and your hands have got you covered.
If you want to learn how to save $1000 on reconditioning a battery
))=)=)Get The Complete Course on How to Recondition a battery=)=)==(
Prefer Watching
