What Drill Waste Management Equipment We Offer?
About Drill Waste Management Equipment,KOSUN offer the Vertical Cuttings Dryer, High Speed Decanter Centrifuge, Screw Conveyor, Mud agitator,Screw Pumps, Mud Tanks that utilized for oilfield drilling waste management system, drilling cuttings disposal plant etc. A rich experience of world-wide sales and operation allows us to make the equipment and system according to your local requirements from mechanical structure to electrical system, no matter the US, EU, Middle East or Austria, Africa.
Vertical Cuttings Dryer can effectively recover the cuttings in liquid phase composition, the solid phase becomes very dry, the drilling mud in the recovery, reduce the cost of drilling operation, but also reduces the the pollution of the environment, in accordance with international emission standards and environmental protection requirements. It can be used for drilling cuttings in land and ocean drilling.With the continuous improvement of environmental protection requirements, the major oil fields are faced with the problem of drilling waste disposal.
High Speed Decanter Centrifuge is used in separating suspension of solids phase with particle ≥2μm in diameter, and can be used at Environmental Protection Industry, Chemical Industry, Food Industry, Pharmaceutical Industry,and many other related industries, and can the replacement of GEA westfalia centrifuges or Alfa Laval centrifuge.
Screw conveyor (Auger)can be used in drilling waste management projects, providing an effective and low-cost drilling cuttings transport system for offshore and onshore drilling rigs. Adopting a multi-sectional composite structure with each section of 12 feet (3.66m), the screw conveyor can be flexibly assembled on different drilling sites, with characteristics of simple operation, stable structure, strong adaptability and high safety, significantly improving the operating efficiency of equipment and reducing the cost and resources. The flights of screw conveyer adopt wear-resistant material to ensure its service life.
Mud agitator mainly used to agitate and mix the drilling mud to prevent solids particles from depositing in the circulating tank and to stabilize the performance of drilling fluids.
Drilling waste management, in many parts of the world, are probably the biggest challenge facing the industry today. To meet the environmental compliance, stringent limitations concerning the discharge of Non-Aqueous Fluid (NAF) contaminated drill cuttings to the environment have been addressed by governments. To comply with these requirements, specialized technology has been developed to further treat the drill cuttings after the normal Solids Control Equipment.
KOSUN offers Vertical Cuttings Dryer and Decanter Centrifuges to get them into a solution that can dramatically reduce waste volume and reclaim much drilling fluids back to the active mud system, and meet increasingly strict environmental regulations. (Editor:Kosun Lily.Wang)