Step-By-Step Guide to Replace Shower Ring from Leaking Shower Tweed Heads

Your bathroom is undoubtedly the most important place because whether it’s about taking a shower or taking a bath, this place only would be used. Because of excessive use, it becomes dirty faster than others and several of its components start to malfunction and the top name in the list is of the shower, as it could start leaking literally for no reason. If you are also experiencing leaking shower Tweed Heads, continue reading this post as we have come up with a step-by-step guide to tackle the issue and resolve it at the earliest.

According to shower regrouting experts, the problem of leaking shower Tweed Heads could arise due to worn out rings. These leaks could also get generated through the hose or the electric box on the wall. Therefore, by replacing this ring, this issue can be resolved and for this, the following steps would be necessary.

Damaged shower ring

Step 1

· According to shower repairs Gold Coast experts, the first step is unscrewing the shower head and checking the condition of the ring.

· In most cases, you will find this ring beneath the ball.

Step 2

· The second step involves checking the gasket and if it is damaged, you will find it leaving black soot like marks.

· In case, it is damaged, remove the gasket and take to your local hardware store and seek another totally similar looking gasket or the current size of ring.

Step 3

· Now its time to push the ring in its place and when done, you need to wrap all the pieces of Teflon tape with the threads.

Step 4

· Once done, you can now rescrew the shower head back and test it by switching on the water supply.

· Experts of shower repairs recommend that too much of tightening should be avoided as it will rise the risk of damaging the rubber or threads.

· However, if the head refuses to come face to face, you will have to use petroleum jelly or grease and leaving it for an hour and then, retrying one more time.

· Experts even raised an issue that you should never try to over tighten joints, as this may crack the head assembly.

In case the leaking shower Tweed Heads is troubling you and not allowing you to work efficiently, you will have to take the following steps.

· Turn off the water supply.

· Remove the faucet handle and then the cap.

· Using a wrench to remove the diverter valve.

· Unscrewing the assembly, taking out the stem and checking the washer. If worn out, take both the valve and washer.

· Clean all of the assembly and after getting the replaced parts, reassemble all of them back.

· Turn on the water supply and check to see any drips.

· Re-tighten the shower head once again.

Problems caused by leaking shower Tweed Heads.

· The leaking water can cause damp and mold and will be noticed by the dark patches and bad smell that it leaves.

· The appliance will need to be resealed in order to solve the problem.