you get the Canon B200 error code, we have compiled a list of solutions for this common printer error.
Although Canon recommends some generic solutions, such as turning the printer on and off, we have found more robust solutions that involve working with printheads.
Canon B200 Error Code
We have seen this error in mg6320, mp560, mx870, mx922, mp620, mg522 and more Canon models. It is necessary to clarify that reinstalling the canon drivers is not the solution but if you need installers enter here: canon drivers
Check the patches below and see if they work. The videos provide step-by-step guides to solve the problem.
Keep in mind, however, that the dissection of your printer may void the warranty, so the best first step could be to contact Canon Support.
5 fixes for Canon B200 error code: Solution # 1 (YouTube patch)
The YouTube creator of Stripes and Circles published a popular solution to this Canon error code that warned him to “unplug the power cord and contact the service center.”
The solution starts by turning off the printer, unplugging, then moving the printer head to the center and turning it on again.
Once it is turned on again, before the printer head returns to the right and before it reaches the left, it says to turn off, wait for it to restart now, and verify if the error code has been erased .
Watch the full video for the above correction and others who tried to erase this error from your Canon printer.
5 fixes for Canon B200 error code: Solution # 2 (YouTube Fix # 2)
According to this video creator, Computerhilfen, the way to solve the error of the Canon B200 printer is to replace the empty ink cartridges and clean the print head.
Note, however, that this could void the warranty and contact Canon Support before attempting a solution.
5 fixes for Canon B200 error code: Solution # 3 (YouTube Fix # 3)
The YouTube Refresh Cartridge chain posted a fix in the Canon b200 error message. He says that, in his experience, this error is usually related to a printhead problem on his inkjet printer.
Although he says that some of Canon’s support threads indicate that it may occur due to an obstruction or something in his printer that prevents the crib from moving, in his experience this has not been the case.
The common remedy is to turn off the printer for a few minutes, remove obstructions, turn on the printer and erase it. But if that does not work for you, one of the first solutions recommended is the inspection of the electrical error in the printhead.
He says that the patch varies according to the number of cartridges he uses. With a 5 Plus cartridge printer, it is more difficult because the print head will be located inside the printer. If so, please contact Canon Support.
See the video of the step-by-step guide to solve this error.
YouTube comment corrector
One owner of the Canon printer, in the comments section, explained that he had the 5-ink cartridge version, and published a solution that worked for him:
1-Disconnect the power
2-Open the print head compartment (as if you were changing the ink)
3-Power on
4-Wait until the print carriage starts moving to the left and let it go halfway
5-Just before the print carriage reaches the left side (but after halfway), close the lid
6-Leave the printer on
7-Check if it is fixed
5 fixes for Canon B200 error code: Solution #4 (Correction of the application)
According to the popular Appuals technical repair website, the patches vary depending on whether you have a Canon printer with 2 or 4 cartridges.
Corrections involve working with printheads and cartridges. Check the b200 error code patch step by step in Appuals.
5 fixes for Canon B200 error code: Solution # 5 (Canon Support)
A Canon support thread has a detailed solution.
This involves removing the print head, making sure that the print head is properly aligned with the front frame.
The user of Canon stated that he engraved his gold contacts with adhesive tape to protect them from water and ink contamination.
See the complete solution in the Canon Support thread previously linked.
summary
As always, if the above corrections do not work for you, we recommend that you contact the manufacturer’s support.
