4S Zinc Galvanizing Spray is a highly effective Zinc-rich touch-up spray offered by Samraj Polytex Ltd. that provides cold galvanizing coating to protect any metal surface from rust & corrosion. It is a convenient smooth flowing spray that stops rust & corrosion on any ferrous or non-ferrous metal surface. It sprays Zinc-rich coating which electro-chemically bonds with metal. And forms highly adhesive, fast drying & permanent primer layer on metal surface to prevent it from rust & corrosion indoors & outdoors.
4S Zinc Galvanizing Spray can also be used as primer over rusted metal to repair hot dip galvanizing or galvanized surfaces damaged due to cutting, drilling & welding. It is specially formulated by advanced technology to provide a tough & durable zinc coating that will not crack or peel-off even in extreme cold or hot conditions.
Features of 4S Zinc Galvanizing Spray:
- Colour = Silver
- Zinc Percentage = 46 %
- Spraying Area = 1.5 m2
- Dry Film Thickness = 40 μm
- Drying Time = 20~30 min
- Durability = 3 years
- Environmental Safety = No CFCs (Ozone Friendly)
Uses of 4S Zinc Spray :
- Used as cold galvanization paint for metal surfaces.
- Used to repair damaged galvanized surfaces or steel structures.
- Allows deposition of metallic zinc coating which protects metal surface from rust and corrosion.
- Used as protective paint on iron, steel, woodwork, roof coverings, piping, galvanized sheet iron, etc.
- Used as water-resistant on marine equipment & off shore steel structures to prevent them from corrosion.
- Used on telecommunication towers to prevent rusting from rain.
- Used on cable trays, galvanized gratings, steel pipes and tubes, etc.
- Used widely in power plant and sub-station equipment etc.
- Used as primer on galvanized ducts, fences, gutters, trucks, trailers, etc.
- Used on automobile, car, bike, etc. underbodies and parts to enhance their life.
Directions of Usage :
- Shake well before use. Shake the can vigorously for 1–2 minutes so the mixing balls in the can begins to rattle & mix the paint.
- Spray through the nozzle of can with a distance of 15–30 cm.
- Shake often during use & keep the can in motion while spraying.
- For best result apply thin even film.
- Check on small area of the part before final use.
- Use in well ventilated condition.
- Put the cap after usage of 4S Zinc Galvanizing Spray.
