Torah vortex node deployment tutorial(new update)
1. Install MetaMask, add Matic network, and open the website https://polygonscan.com/
Pull to the bottom:
2. After adding, switch to matic network:
3. Check your contract address and refer the coin to the matic address:
4. Enter https://github.com/Torahserve, download the Torah farmer program and documentation, etc.;
5. Double-click Torah Setup.exe and install the farmer combination program according to the prompts;
6. Click the Setup menu and fill in the relevant data;
7. location: Select the data disk to deploy the vortex node;
8. Numbe: Fill in the number of vortex nodes that need to be deployed, please set it reasonably according to the hardware configuration;
9. Password: Set the private key password of the vortex node;
10. Boot-node: According to the geographical distribution of your equipment deployment, select the node link point;
11. Swap-endpoint: Enter https://infura.io/, register and activate the account by email;
12. Create and name your Swap endpoint;
13. In KEYS, select the Polygon mainnet network, copy the node link and fill in the Swap-endpoint column;
Note: To ensure the efficiency of swirl nodes, each Swap-endpoint supports at most two nodes;
14. After completing the selection, click Create to save the settings;
NEW UPDATE:INFURA NO LONGER PROVIDE FREE END-POINT
To resolve this issue, please use this end-point:
https://rpc-mainnet.maticvigil.com/
In addition to that
15. Start the node, click Setup to run run-node, and wait for the node to be automatically generated;
16. Activate the node, click Setup to run active-node, click refresh, and wait for the completion of automatically obtaining node data;
17. Click the right mouse button to copy the node address, and deposit 0.5 MATIC as Gas and 100 VP to the contract address;
18. If an error occurs during deployment, restart the device and open the software, start the vortex node program, click Setup to run Run-node, wait for the vortex node to start automatically, then click Setup to run Node-status, click Refresh, and wait for the vortex node data to be automatically obtained After that, the program will automatically start the farmer program.
Want to learn more?
Want to follow the project and learn about its upcoming launch? Join the Torah community below:
Twitter: https://twitter.com/torah1network
Telegram：https://t.me/Torahnetwork
