How to DIY project bathroom wall panels

👉Tools require for installing: Caulking gun, Drill, Tape measure
👉Step 1
Using a measuring tape, mark and cut the panels to match the various places on your shower walls. When cutting, use a clamp to hold the sheets together and prevent rattling. When cutting through your panel, you can also use a “sacrificial board” to keep the panel from vibrating.
To make holes in the panels, use a blunt drill. It is not recommended to screw or fix anything into the panels physically. Before attaching the panel to the wall, make sure you pre-drill all required holes.
👉Step 2
The premium quality adhesive should be applied in 6mm diameter beads spaced 100mm apart. Make sure that the beads are used in the cut-outs.
👉Step 3
The shower panel should be attached to the wall within 30 minutes after applying the adhesive. Please use a straight edge to apply enough pressure to the sheet so that it is uniformly distributed throughout, resulting in a uniform finish.
Allow for a 3mm expansion gap between each sheet of paper. Use firm pressure to press each panel flush against the wall, compressing each bead to the 3mm spacing and allowing greater adherence. Double-sided tape can secure the sheets in place while the silicone cures.
👉Step 4
The panel should be sealed around the perimeters, cut-outs, and edges using neutral cure silicone, extending approximately 50mm from each panel border. Run the silicone down all inside corners to seal them and prevent water from penetrating the wall structure.
👉Step 5
Remove the thin protective layer from the ornamental face of your newly installed acrylic shower panels after they have been cleaned and prepared. Use of abrasive cleaners or materials on your panels is strictly prohibited. When cleaning your shower panels, warm water, and light detergent is more than sufficient.

For more information about the acrylic shower panels, contact Website: https://www.tthbuilder.com/contact-us
Phone no.: (206) 258–9103