Adding a Ram Mount to the #%@#$@! A-pillar

November 1, 2017.

I’ve always hated the A-pillars in my truck. Actually, it’s the trim I hate. And I’ve hated it since I first tried (and failed) to remove it several years ago to run the wire for a microphone from my head unit up to the rearview mirror.

See, to remove the A-pillar trip, you also need to remove the grab handle. And for some reason, in 1997–2000 Tacoma’s, the grab handle is attached with two M6 screws (no hex head) with a JIS head. That JIS head looks a lot like a Philips head, but it isn’t, and I of course don’t have a JIS driver.

So I use Philips, and hope.

Or rather, I generally try to avoid removal.

In fact, several years ago when I failed at removing the grab handle because I could tell the screw head was going to strip, I even went so far as to purchase some M6 socket button head screws that I could use to replace the OEM ones. But I never installed them because, well, that would require messing with the A-pillar.

But today I decided it was time to mount a 1" Ram mount ball on the driver side A-pillar. I needed it for some communication equipment, and frankly, it was time to fix the problem once and for all.

I was able to get the first screw out! The head didn’t look great, but it held long enough to back out. Maybe I could do this.

But the second head was already a bit mangled from my attempt years ago. Almost immediately, it completely stripped out. Semi-expected, I retrieved my drill, a bit to drill out the head, and my screw extractors.

But then there was another problem. I couldn’t fit the drill+bit into the head of the screw because the steering wheel was in the way. So, out came the steering wheel…which of course also means the airbag had to come out, and I risked re-installing the steering wheel “off-a-tooth” when putting it back on.

Then, I drilled out the head of the screw and screwed in the extractor.

And then, even though I’d used a small extractor, the head broke off. At least that mean that the grab handle was free! Of course, it also meant that I still needed to get the screw shank out. So it was back to drilling and “extracting.” Except the extracting didn’t work — I just couldn’t get the screw to back out. Eventually, I drilled out enough of the shank that it just “fell out.” And by that point, a couple hours had passed, and tools had been gathered.

The next step was to remove the A-pillar trim, so I could run wiring cleanly to the Ram mount. I did everything by the book — went slowly, pried carefully. I only broke one clip. “Meh success,” I guess. #%@#$@! A-pillar

Now it was time to figure out how to attach the Ram mount. To see how I did it (ingeniously I dare say), check out Adding a Ram Mount to the #@#%#! A-pillar at adventuretaco.com.

Originally published at adventuretaco.com.