Manually Creating a REST Connector: Pega How-to Guide

Actually, it is easier to manually create the REST Connector. To do that, in the “Records Explorer”, just navigate as follows:

• Expand the “Integration-Connectors”
• Right-click on “Connect REST”
• Left-click on the “Create”

Figure 68: Connect REST Menu Navigation

In the form that opened, enter the following info, followed by clicking on “Create and open”.

Figure 69: Connect REST Record Configuration

In the created rule, for the following tabs, enter the information accordingly.

Service Tab

Fill in the “Resource path” as the “Service endpoint URL” of the Service REST.

Figure 70: Service Tab of Connect REST

Note: You can copy the “Service endpoint URL” from the earlier Service REST.

Methods Tab

GET Method

In the Methods tab, for “Get”, under the “Response”, for the “Message Data”, specify it as follows:

Figure 71: DBRestConnector GET Method Response Configuration

Note: There is nothing to configure for the “Request” since this particular service of ours does not have any inputs!

POST Method

Similarly, for the “Post”, configure the “Request” and “Response” as follows:

Figure 72: DBRestConnector POST Method Request Configuration

Figure 73: DBRestConnector POST Method Response Configuration

OK! Our REST Connector is ready! It is now able to support both “GET” and “POST” method. The next step is to test our REST Connector.

To test the REST Connector, let’s use a Datapage to do that!

[Back to Online Version content page]

[Check the How-to Series availability here]