IPAD V2 Claiming Tutorial

Step by Step guide on the claiming process

Users who wish to claim their tokens, either to have them available in their wallets or want to swap the tokens will need to use this claim procedure described in this step by step guide.

NOTE : Those who have been staking or holding IPAD tokens DO NOT need to take these steps as your IPAD V2 Tokens are ALREADY staked in the contract and allow you to take part in the upcoming fundraises.

Only proceed if you want to unstake IPAD V2 Tokens. Do not proceed with the following steps if you want to remain staked.

To unstake and claim IPAD

https://bscscan.com/address/0xDa9ff936Bd32A41A55fA167598A6D0F030D52b39#writeContract

To remove Liquidity and Claim LP

https://bscscan.com/address/0xDea96CEFBE822a14FaeBAE5E4815B2ff2fb84CF7#writeContract

2. Make sure to press on the “connect to Web3” button in the lower frame.

3. Once you have clicked, a pop up window will open for you to select the appropriate wallet service. Select the one you are using. Make sure to have Metamask extension installed in your browser.

4. After selection, a pop up will prompt you to connect the wallet to BSCscan, press Connect.

5. BSC Scan may send another pop-up, press OK.

6. Head to the bottom section of the page and click on “requestClaim”. It will reveal a blue button that reads: Write.
Press on the WRITE button.

7. A transaction will appear, this transaction needs to be approved.
Review the gas fee and press CONFIRM.

READ Carefully

Congratulations you have finished all the required step to initiate the unstake and claim.

To have 0% fee, you can now wait 15 full days before going to the next step

OR

15% fee will be applied if you decide to go to the next step immediately.

8. Final step: Once you have waited 15 days OR you decided to still move forward with a 15% fee, you can press on the WRITE button that is located in the “CLAIM” tab. Once clicked, a transaction will pop-up and you will need to approve it after which, IPAD tokens will be in your wallet