Logi Design Advice
Published in

Logi Design Advice

What do the buttons on the Rally System Remote do?

  1. Bluetooth® pairing
  2. Call answer
  3. Call end
  4. Microphone mute
  5. Zoom in/out
  6. Volume up/down
  7. Home
  8. Camera pan/tilt
  9. Camera preset

Change the default home position on the camera

You can change the default home position to whatever position is most appropriate to the room configuration. Pan, tilt and zoom can be adjusted to the desired position and this can be set as the new home.

This can be done as follows:

  • Move the pan, tilt, and zoom to the desired placement.
  • Now hold down the Home button on the remote control for about 10 seconds. A tone will play from the speaker when set.

PAIRING the remote control to the Rally Plus

RALLY PLUS and the remote control are paired at the factory.

You can pair up to 5 remote controls to RALLY PLUS to make it easier to control the system in larger rooms.

Or, if you need to pair a remote to the camera, such as when replacing a lost remote, do the following:

  1. Press and hold button on the back of the camera until the LED flashes blue.
  2. Press and hold the pairing button on the Display Hub until the LED flashes white.
  3. Press and hold the Bluetooth button on the remote for 10 seconds to place it in pairing mode.
  4. Once the remote and camera are paired the LED will stop flashing.
  5. Once the Display Hub and camera are paired the LED will stop flashing.
  6. If the pairing fails, the LEDs will keep flashing for 2 minutes then stop. Start from step 2 and repeat

--

--

Get the Medium app

A button that says 'Download on the App Store', and if clicked it will lead you to the iOS App store
A button that says 'Get it on, Google Play', and if clicked it will lead you to the Google Play store