Arduino Pro Mini — Flashing
Having Trouble Flashing ProMini — FTDI Cable — Ardu_Serie#67
I spent a lot of time trying to flash my Arduino Pro-mini :/
For your convenience here are the tips that will save your time!
List Of Materials
Connections:
UartSBee — Arduino Pro-Mini
DTR — DTR
RX — TX0
TX — RX1
VCC — VCC
CTS — GND
GND — GNDnote: Check over your clone; may be different from mine Arduino Promini ;)
Now open the Arduino IDE
1 — TOOLS> Board Arduino Pro or Pro Mini
2 — My card is 5 volts 16 MHz (check yours);
3 — Programmer leave in AVR ISP
4 — Check the settings set below:
Arduino Pro or Pro-Mini, ATmega328P, (5v16 Mhz) on COM15;
Run the sketch blink and see if the LED of the board obeys your command; modify to 100 ms to clear the doubts 😊
That’s it!
Thank you for reading.
This is your host, J3!
Bye for now!
[TODO: VEDEO GOES HERE!]
Download All Files For This Project
Related Posts
J3 Solar Tracker Turret V1.0–100th Pub Youtube Video about Arduino #arduSerie 100
Solar Turret V 1.1 — Improving Design 4 Learning More — ArduSerie #69
References & Credits
Dupont Crimp Tool Tutorial
https://www.meccanismocomplesso.org/en/cavetti-jumper-dupont-arduino-breadboards/