{:en}How to Fix a Bricked 3D Printer board. (installing a bootloader){:}{:es}Cómo arreglar una placa rota de impresora 3D. (instalación de sistema de arranque){:}

{:en}

How to Fix a Bricked…

DIY 3D Printer from scratch — Heated bed

Welcome to 3DPrinterChat.com, this article is part of the DIY 3D Printer from scratch, and you will learn a bit more about how the Heated bed works.

3D Printable Tools — For Your Workbench 2017

Every workshop needs a 3D Printer right? And every 3D Printer owner needs to use…

How To use TinkerCAD to Fix .stl files

How To use TinkerCAD to Fix .stl files

As a 3D modeller, I like to think the designs I spend weeks building come out perfect and ready to 3D print.
Like all modelers, realty hits hard when I open the .stl in the slicer program. All…

Adding text to 3D objetcs using 3D builder

3D builder is a slicing software from microsoft but you can also edit your 3D files, if you need to add rapid text trough your 3D files perhaps 3D builder is for you. check how is done.

How To Hot Iron Finish a Rough 3D Print Using a Clothing Iron

3D printers like to think that the print comes clean off the build plate of their printer. After a couple long and complex prints, the reality of 3D printing hits hard.

DIY 3D Printer from scratch — Bowden vs Direct Drive

3D Printer Filament Guide & Comparison Chart

There is a huge amount of 3D printing materials, as there is an infinite amount of…

{:en}SD-Card Vs. Repetier Host{:}{:es}Tarjeta SD Vs. Repetier Host{:}

{:en}Best way to send G-code to your 3D Printer.

Note: This analysis is based on my experiences with Repetier Host and the Wanhao Duplicator i3 V2. Other programs and printers may work…

Heated bed too slow to heat? check some possible fixes