cmendes0101

Relay Controller Board Complete

Got down to etching the new board. I didnt do the transfer that well so there were spots around the edges with flacky connections so had to use those trace repair pens.

Swapping to pumps

The pressure system just didnt work out. Swapping to pumps. I picked all of them up last month and got them cleaned and ready to start using. I had to swap out the quick connects on one side of the valves so now they are regular barbs. I left the quick connects on the spout side since I like that…

New Mickey’s, Grey Goose, Belvedere Hookahs

Finally got to knock out a few bottles that I had sitting around. Just been trying to collect larger liquor bottles.

[caption id=”attachment_287" align=”aligncenter” width=”600"]

Printrbot Finally Running

After months of waiting, I finally got my Printrbot LC from the Kickstarter campaign. It definitely takes a while to build and have to watch tons of YouTube build videos since there wasn’t any written instructions but it’s running. I picked up the power supply enclosure and holds…

Low Cost Routing on Asterisk with Postgres and Prefix range module

Asterisk doesn’t have a good setup for low cost routing (LCR) so years ago I borrowed Freeswitch’s mod_lcr with MySQL setup to get multiple vendors in place. This helped to lower cost by picking the lower cost route…

2nd Automated Bar Demo w/ Video

Cleaned and replaced a bunch of wiring that was using jumpers to something a little better. Rewrote the arduino code to allow all bottles to pour at once and stop when needed instead of a bottle at a time.