DC Stepper Motor Driver Board —.8A@12 v peak — Ardu_Serie#62
Hi, This is a DC Stepper Motor Driver Board L9110S H Bridge for Arduino
The code:
Note:
I put 9 volt half amps for two 12 volt motors and the chips on that board got very hot. I think the maximum should be about 9 volts;for Actually this board is suitable for small motors of 5 to 9 volts:/
For more information please see this post too:)
Download All Files For This Project
Credits & References
28BYJ-48–5V Stepper Motor datasheet
Sparkfun — Motors and Drivers
Related Posts:
Meet DoRobot — Assembly Techniques J3 Caterpillar-Crawler-Chassis v 1.0 — ArduSerie#46
EASYDRIVER: 4-Wire-Stepper Motor Driver — Brian Schmalz Design on A3967 IC — Bi-Polar Motors — .75A@30v peak — Making Using These a Breeze! Ardu_Serie#48
DRV8825 — High Current Stepper Motor Driver Carrier — Stepper Motor — Bipolar Mode — 2.5A@45v peak — Ardu_Serie #59
L298N — Dual Full-Bridge Driver — Darlington Transistor Arrays Based — 3A@50v peak — Ardu-Serie#52
TB6612FNG: Dual DC Motor Driver — SparkFun Motor Driver — 3.2A@13.5v peak — Ardu-Serie#49
A4988 — Stepper Motor Driver Carrier — Allegro’s A4988 — Bipolar Stepper Motor Driver — 2A@35v peak — Ardu-Serie#53
Adafruit Motor Shield v1 & v2–4 DC Motors or 2 Stepper Motor or 2 Servos — 1.2A@25v & 3.2A@15v peak — Ardu-Serie#54
IFR 520 MOS — Module + DoRobot — Switch Heavy DC Loads — 10A@100v peak — Ardu-Serie#60
L9110 H-bridge module + DoRobot — DC Stepper Motor Driver Board — .8A@12 v peak — Ardu_Serie#62
BTS7960B- High Current PN Half Bridge — High Current Motor Drive Applications — NovalithIC T M — 43A@24v peak — ArduSerie#64
VNH2SP30 — Monster Moto Shield — Use This Board In Extreme High-Demand Application — Full-Bridge Motor Drivers — 30A@16v peak — Ardu_Serie#63